Increasing the Number of
Outputs from a Clock Source Using Low Jitter LVPECL Fanout Buffers
- The EVAL-ADF4351EB1Z board uses the standard ADF4351 programming software
contained on the CD that accompanies the evaluation board. CIRCUIT EVALUATION AND TEST, Getting Started The
UG-435 user guide details the installation and use of the EVAL-ADF4351EB1Z evaluation software. Install the
ADF435x software to PC by doing the following: . . . [Analog Devices-Circuits from the Lab]
Laser Used As
Vehicular Traffic Counter - This is an
illustration how a laser could be used to count traffic and measure the speed of each car passing through the
sensor area . . . [Circuit by Dave Johnson P.E., 01/07/07]
LCD Clock/Calendar - LCD Display with Date and Time, 12hr format. . . . [Jose Pino]
LCD
Display - STMicroelectronics-Application. . .
LED Clock - 12Hr LED clock using 16F628. Also, schematic to build a Jumbo clock is included. . . [Jose
Pino]
LED Clock with Timer & Solar Panel
Regulator - This is a combination digital clock timer
and solar panel charge controller used to maintain a deep cycle battery from a solar panel. The timer output
is used to control a 12 volt load for a 32 minute time interval each day. Start time is set using 9 dip
switches and ends 32 minutes later. The 32 minute duration is set by selecting the 5th bit (2^5 = 32) of a
4040 binary counter (pin 2). The timer also has a manual toggle switch so the load can be manually switched
on or off and automatically shuts off after 32 minutes. . . [Bill Bowden, designer]
<<<< Previous PAGE
Next >>>> |