|
Analog-to-Digital Conversion by using V/F Converters - AN-276 Analog
Devices Application Notes (app note added 2/06) |
|
Analog-to-Digital Conversion Notes - (electronic circuit added 4/05)
|
|
Analog-to-Digital Conversion Techniques with COPS Family MicroControllers -
National Semiconductor Application Note (app note added 2/06) |
|
Analogue to Digital Converter - Normally analogue-to-digital con-verter
(ADC) needs interfacing through a microprocessor to convert analogue data into
digital format. This requires hardware and necessary software, resulting in
increased complexity and hence the total cost…. |
|
Analogue to Digital Converter for PC Serial Port - This circuit is a
simple 8-bit analogue to digital converter circuit which is connects to PC serial
port. The circuit is based on TLC548 A/D-converter chip (might be hard to get
nowadays, Texas Instruments makes this IC), which is an A/D-converter with serial
output. The output of the TLC548 is not directly suitable for standard serial data
reception, so this circuit uses serial port handshaking lines... [by Tomi Engdahl] |
|
Aperture Uncertainty & ADC System Performance - AN-501 Analog Devices
Application Notes (app note added 2/06) A Key Concern in IF Sampling
is that of Aperture Uncertainty (Jitter) |
|
Application Considerations for the Convert Start Input CONVST Bar of the
AD7822/AD7825/AD7827/AD7829 - AN-592 Analog Devices Application Notes
(app note added 2/06) |
|
Application Hints for the CS501X Series of A/D Converters - (app note
added 6/07) |
|
Applications for the AD537 Voltage to Frequency Converter - AN-277
Analog Devices Application Notes (app note added 2/06) |
|
Applications of theADC1210 CMOS A/D Converter - National Semiconductor
Application Note (app note added 2/06) |
|
Ask the Applications Engineer 1-Multi Troubles - AN-354 Analog Devices
Application Notes (app note added 2/06) Addresses problems often
encountered with LOG Circuits, Time Division Analog Multiplexing, and ADC Power
Strobing |
|
Ask the Applications Engineer V/F Converters - AN-361 Analog Devices
Application Notes (app note added 2/06) |
|
Ask the Applications Engineer-2 - AN-351 Analog Devices Application
Notes (app note added 2/06) Trimming Offset and Gain in A/D's and
D/A's |
|
Associated reference code for EE-139 - EE-139 Analog Devices Application
Notes (app note added 2/06) |
|
Asynchronous Clock Interfacing with the AD7878 - AN-291 Analog Devices
Application Notes (app note added 2/06) |
|
A-To-D Converter Does Frequency Translation - DN259 Design Notes
(Linear Technology) (app note added 1/06) |
|
Autocalibrator Nulls DC Offsets - 06/09/94 EDN-Design Ideas Three
inexpensive ICs in Fig 1's autocalibration circuit correct for both ADC's
offset errors and systematic dc offsets that accumulate before converter
input. An RS flip-flop, a counter, and a low-cost DAC combine to provide
requisite offset correction voltage. When configured in unipolar mode, IC1, a
12-bit 1.25-Msamples/sec ADC, has a maximum dc offset of ±9 LSBs, which this
autocalibration circuit can reduce to less than 1/2 LSB.... [Design Idea by Doug
Mercer and Steve Ruscak, Analog Devices, Wilmington, MA] |
|
Automating ADC Data Collection - Maxim Application Notes / 929 / Jun-04
(app note added 5/08) |
|
Auto-Zeroing A/D Offset Voltage - DN26 Design Notes (Linear
Technology) (app note added 1/06) |
|
Avoiding Passive-Component Pitfalls - AN-348 Analog Devices Application
Notes (app note added 2/06) The Wrong Passive Component Can Derail
Even Best Op Amp or Data Converter. Here Are Some Basic Traps to Watch For.
|
