Matched offsets put signals into ADC's range 12/09/99 EDN-Design Ideas The circuit in Figure 1 measures a voltage that is negative with respect to the system’s ground point.  The constraint is that the a single supply powers the ADC, and its ground point is fixed relative to the measured voltage.   PDF has several circuits, scoll to find this one.__ Circuit Design by Michael Petersen, Iowa State University, Ames, IA

Matched Resistor Networks for Precision Amplifier Applications 10/03/13  EDN-Design Notes   Two-quadrant multiplying DAC utilizes octal CMOS buffer.  Some ideal op amp configurations assume that the feedback resistors exhibit perfect matching.  In practice, resistor non-idealities can affect various circuit parameters such as common mode rejection ratio (CMRR), harmonic distortion and stability.  For instance, as shown in Figure 1, a single-ended amplifier configured to level-shift a ground-referenced signal to a common mode of 2.5V needs a good CMRR.  Assuming 34dB CMRR and no input signal, this 2.5V level shifter exhibits an output offset of 50mV, which can even overwhelm the LSB and offset errors of 12-bit ADCs and drivers.__ Circuit Design by Linear Technology Design Note 502

Micropower ADC & DAC in SO-8 Give PCs a 12-Bit Analog Interface DN138 Design Notes___ Linear Technology/Analog Devices

Micropower MSOP 10-Bit ADC Samples at 500ksps DN184 Design Notes___ Linear Technology/Analog Devices

Micropower SO-8 8-Bit ADCs Sample at 1kHz on 3µA of Supply Current LTC1096 & 1098 DN60 Design Notes___ Linear Technology/Analog Devices

Mini-Circuits AD Family Customer Soldering of Matte Tin Plating AN-00-0-04 App Note___ MiniCircuits.com

Missing-codes tester checks 16-bit ADC in 7 sec 06/10/99 EDN-Design Ideas As the resolution of ADCs increases from 12 to 16 bits and higher, the difficulty in testing the"nomissing-codes"specification grows proportionately.  To fully guarantee no missing codes for a 16-bit ADC requires testing all 2 16-1 possible output__ Circuit Design by Mark A Shill, Burr-Brown Corp, Tucson, AZ

Monitor & balance large lithium-Ion batteries 09/03/07  EDN-Design Ideas Using a microcontroller's built-in ADC to measure cell voltage and temperature, this lithium-ion cell monitor equalizes the cell voltage and signals alarm conditions__ Circuit Design by Daniel Gomez-Ibanez, Woods Hole Oceanographic Institution, Woods Hole, MA

New 14-Bit 800ksps ADC Upgrades 12-Bit Systems with 81.5db Sinad 95db Sfdr DN159 Design Notes___ Linear Technology/Analog Devices

New 16-Bit 100ksps A/D Converter Runs on 5V Supply DN165 Design Notes___ Linear Technology/Analog Devices

New 500ksps & 600ksps ADCs Match Needs of High Speed Applications DN88 Design Notes___ Linear Technology/Analog Devices

New 5V & 3V 12-Bit ADCs Sample at 300kHz on 75mW & 140kHz on 12mw DN66 Design Notes___ Linear Technology/Analog Devices

A/D Converters: #'s      A      B - E      F - L      M - N      O - R      S - Z